Special Tools Required
Holder handle ( 07JAB-0010200)
| 1. | Remove the front tires/wheels. |
| 2. | Remove the splash shield. |
| 3. | Hold the pulley with handle (A) and holder attachment (B).
|
| 4. | Remove the bolt with a 19 mm socket (C) and breaker bar. |
| 1. | Clean the crankshaft pulley (A), crankshaft (B), bolt (C), and washer (D). Lubricate as shown below.
|
| 2. | Install the crankshaft pulley, and hold the pulley with handle (A) and holder attachment (B).
|
| 3. | Tighten the bolt to 54 N·m (5.5 kgf·m, 40 lbf·ft) with a torque wrench and 19 mm socket (C). Do not use an impact wrench. If you are using a new pulley bolt or new crankshaft, tighten the bolt to 177 N·m (18.0 kgf·m, 130 lbf·ft) with a torque wrench and 19 mm socket, loosen the bolt and tighten it 54 N·m (5.5 kgf·m, 40 lbf·ft). |
| 4. | Tighten the pulley bolt an additional 90°. |
| 5. | Install the splash shield. |
| 6. | Install front tires/wheels. |