| 1. | Remove the steering column covers upper and lower. |
| 2. | Remove the driver's airbag from the steering wheel. |
| 3. | Disconnect the main switch (7SPEED MODE)/steering shift switch connector (A).
|
| 4. | Check the main switch (7SPEED MODE) for continuity between connector terminals No. 1 and No. 2. There should be toggled continuity and no continuity between terminals every time the main switch (7SPEED MODE) (B) pushes. |
| 5. | Check the steering shift switch plus (+) for continuity between connector terminals No. 4 and No. 2. There should be continuity while pressing both plus (+) of the steering shift switches, and no continuity when the plus (+) switch released. |
| 6. | Check the steering shift switch minus (-) for continuity between connector terminals No. 3 and No. 2. There should be continuity while pressing both minus (-) of the steering shift switches, and no continuity when the minus (-) switch released. |
| 7. | If either test is faulty, replace the main switch ( 7SPEED MODE)/steering shift switch. If the switch is OK, repair the wire harnesses between the cable reel and the PCM. |