| 1. | Remove the door panel. |
| 2. | Disconnect the 6P *1 (or 3P *2) connector (A) from the power mirror actuator
|
| 3. | Check actuator operation by connecting power and ground according to the table.
|
| 4. | If the mirror fails to work properly, replace the mirror actuator. |
| 5. | Check for continuity between the No. 1 and No. 2 terminals of the 6P connector. There should be continuity. |
| 6. | Check actuator operation by connecting battery power and ground according to the table.
|
| 7. | If the retract actuator fails to work properly, replace the mirror. |