| DTC P1882: | Problem in Inhibitor Solenoid Circuit |
| 1. | Disconnect the inhibitor solenoid connector. |
| 2. | Measure the resistance between connector terminals at the solenoid connector.
Is the resistance 17.1-21.0 W? YES - Go to 3. NO - Replace the inertia switch.n |
| 3. | Disconnect the battery negative terminal. |
| 4. | Disconnect PCM connector C (22P). |
| 5. | Check for continuity between PCM connector terminal C6 and body ground.
Is there continuity? YES - Repair short to ground in the wire between PCM connector terminal C6 and the inertia switch.n NO - Go to 6. |
| 6. | Connect the inhibitor solenoid connector. |
| 7. | Disconnect PCM connector A (31P). |
| 8. | Measure the resistance between PCM connector terminals C6 and A4 or A5.
Is the resistance 17.1-21.0 W? YES - Check for loose terminal fit in the PCM connectors. If necessary, substitute a known-good PCM and recheck.n NO - Repair loose terminals or open in the wire between PCM connector terminals C6, A4 or A5 and the inertia switch.n |