| DTC P0420 (67-1): | Catalytic System Efficiency Below Threshold |
P0137, P0138: Secondary Heated Oxygen Sensor ( secondary HO2S) (Sensor 2)
P0141: Secondary HO2S (Sensor 2) heater
| 1. | Reset the ECM/PCM, then continue to 2 through 5 to reset the readiness code. |
| 2. | Start the engine. Hold the engine at 3,000 rpm (min-1) with no load (in Park or neutral) until the radiator fan comes on. |
| 3. | Drive for about 10 minutes without stopping on a highway or freeway. Your speed can vary. |
| 4. | With the transmission in 4th gear, drive at a steady speed between 80-100 km/h (50-62 mph) for 30 seconds. |
| 5. | Repeat step 4 three times. Between each repetition, close the throttle completely for 1-2 seconds. If the engine is stopped during this part of the procedure, go to 3 and do the procedure again. |
| 6. | Check for a Temporary DTC with the scan tool. Does the scan tool indicate Temporary DTC P0420? YES - Check the TWC. If necessary, replace the TWC.n NO - Check for readiness code completion. If the readiness is complete, it was a intermittent failure, system is OK at this time. If the readiness is incomplete, repeat 2 through 5.n |