| 1. | Disconnect the battery negative cable, then disconnect the positive cable. |
| 2. | Remove the splash shield.
|
| 3. | Disconnect the starter cable (A) from the B terminal on the solenoid, then disconnect the BLK/WHT wire (B) from the S terminal.
|
| 4. | Remove the two bolts holding the starter, then remove the starter. |
| 5. | Install the starter in the reverse order of removal. Make sure the crimped side of the ring terminal (A) is facing out.
|
| 6. | Connect the battery positive cable and negative cable to the battery. |