Ignition Key Switch Test
Ignition Key Switch Test
NOTE: For more key-in beeper information,
refer to the circuit diagram
and
input test.
When the ignition key is not removed, the key-in beeper in the gauge assembly senses ground through the closed ignition key switch. When you open the driver's door, the beeper circuit senses ground through the closed door switch.
1.
Remove the steering column upper and lower covers.
2.
Disconnect the 6P connector.
3.
Check for continuity between the No. 1 and No. 2 terminals.
There should be continuity with the key in the ignition switch.
There should be no continuity with the key removed.