| 1. | Remove the center panel. |
| 2. | Disconnect the 20P connector and antenna lead from the audio unit. |
| 3. | Disconnect the connectors from the heater control panel. |
| 4. | Disconnect the connector from the rear window defogger switch. |
| 5. | Remove the seven mounting screws, then remove the audio unit (A).
|
| 6. | Remove the four mounting screws from the LCD unit (A), then remove the cover (B).
|
| 7. | Remove the two knobs (A). |
| 8. | Remove the sixteen mounting screw from the printed circuit board (B), then remove the printed circuit board and LCD unit.
|
| 9. | Install the reverse order of removal. NOTE: Do not remove the connection of the printed circuit board and the LCD unit. |