1. | Disconnect the negative battery cable, and wait at least 3 minutes before beginning work. |
2. | Remove the front inner fender. |
3. | Disconnect the engine compartment wire harness (or SRS front sensor wire harness) 2P connector (A), and remove the two Torx bolts (B) using a Torx T30 bit, then remove the front sensor (C).
|
1. | Install the new front sensor with new Torx bolts (A), then connect the engine compartment wire harness (or SRS front sensor wire harness) 2P connector (B) to the front sensor (C).
|
2. | Reconnect the battery negative cable. |
3. | After installing the front sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off. |