Parking Brake Check and Adjustment

Parking Brake Check and Adjustment - Rear Drum Brake

Inspection

1. Pull the parking brake lever (A) with 196 N (20 kgf, 44 lbf) of force to fully apply the parking brake. The parking brake lever should be locked within the specified number of clicks (B).

Lever locked clicks: 7-10

2. Adjust the parking brake if the lever clicks are not within the specification.

Adjustment

NOTE: After servicing the rear brake shoe, loosen the parking brake adjusting nut, start the engine, and depress the brake pedal several times to set the self-adjusting brake before adjusting the parking brake.

1. Block the front wheels, then raise the rear of the vehicle, and make sure it is securely supported.

2. Remove the console cover.

3. Pull the parking brake lever up one click.

4. Tighten the adjusting nut (A) until the parking brakes drag slightly when the rear wheels are turned.

5. Release the parking brake lever fully, and check that the parking brakes do not drag when the rear wheels are turned. Readjust if necessary.

6. Make sure the parking brakes are fully applied when the parking brake lever is pulled up fully.

7. Reinstall the console cover.